than when coming from most consumer VCRs. the video signal is far cleaner and "correct". This is very important because when capturing from a Camcorder with a TBC built-in, or when capturing from a Tuner as a Broadcast signal. NOTE: There is not a TBC (time base corrector) feature in the design and no where in the WISChip. mainly the Discrete Cosine Transform (DCT) which basically "De-noised" or filtered the video in preparation for later software crunching steps to be performed on the computer. The WISChip G7007SB performed some of the first steps in MPEG1, MPEG2 and DV video compression. Since the video was not compressed many felt this was higher quality, and that software compression was sufficient. Later faster computers, with faster hard drives and SSDs were sensitive, but not as much as older computers. The hardware option was very important when computers were much slower, it allowed video capture over USB2.0 when the computer might have choked by reducing the data rate and volume of the data being transferred. so they were supported by the Empia driver when 64 bit versions came about. Later they revised the models to all be based on Empia chips, the model numbers were similar to the original model numbers, but the later models did not include a hardware video compression chip. pre-Vista/Windows 7 64 bit, so there were never any 64 bit drivers which supported the DVC130. The reason was Micronas / TDK acquired the technology and declined to continue manufacturing the chips. There were originally three base models, DVC100, DVC130, DVC170 Still not sure how they can do that with drivers that haven't been updated since April, 2012.The DVC130 is not a simple Video Capture device, it is a partial hardware video compression device. They will be used on a Windows XP and Windows 7 system but I've heard of some people say they are using them on Windows 10. I know anyone can buy better inexpensive encoders that work with any modern software but these do exactly what I want then for and I'm trying to expand the limited software packages that work with them because of their propriatary Drivers.Īny tips or tricks to work around the driver limitations would also be great. I knew of a Unofficial fan site of the Dazzle PCI DVC-II and some for the original MPEG-1 DVC that had lots of this type of info but they are no longer around. I don't care how old they are because most can be bought off ebay and some still NEW in seal packages if I knew which ones will work. If you know of any software that works with these units, please post them. I think certain older version of Intervideo software may also work with it. I believe Pinnacle who owns Dazzle did include in later versions of Pinnacle Studio the ability to capture from these older models but I don't know the last version to include these models. I know they work with Moviestar 5, Pinnacle Studio Version 8 & 9. These are the models I'm inquiring about : Also I believe the Dazzle drivers hide the audio stream from most capture software. The drivers are propriatary Drivers and not like most USB video capture devices that use a standard format that most capture software can access. They use Windows XP, Vista & Windows 7 32 bit drivers. I'm looking for software info on two older USB hardware MPEG-2 encoder models.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |